5. ENGINE REMOVAL/INSTALLATION Pulsar CK 125 Carburetor Lock Nut ENGINE REMOVAL Remove the carburetor. (Refer to 4-3.) Disconnect the clutch cable. · Drain the engine oil before engine removal. · The exhaust muffler temperature is extremely high. Remove it when the engine is cold. Clutch Cable Exhaust Muffler Joint Spark Plug Cap Lock Nuts Remove the two exhaust muffler joint lock nuts. Remove the exhaust muffler hanger lock nut and rear fork pivot nut to remove the exhaust muffler. Remove the spark plug cap. Exhaust Muffler Hanger Lock Nuts Generator Wire Bolts Connector Starter Motor Wire Switch the fuel valve OFF and disconnect the fuel tube from the fuel valve. Remove the seat and fuel tank. (Refer to 4-8.) Disconnect the A.C. generator wire connector. Remove the two left rear crankcase cover attaching bolts and the cover. Left Rear Crankcase Cover Drive Chain Set Plate Remove the two drive gear set plate attaching bolts and the set plate. Remove the drive gear and drive chain. Remove the gear shift pedal attaching bolt and the gear shift pedal. Bolts Drive Gear 5-2