new pulsar 125 Workshop-manual : Page 88

          9. CLUTCH/GEAR SHIFT MECHANISM                                             Pulsar   CK   125

                                                                                         Bolts
 Install the tension springs and clutch lifter.
 Install the washers to the bolts and tighten
 the four bolts.
 Torque: 0.81.2kg-m
 Install the clutch lifter guide pin.




                                                             Guide Pin

                                                     Oil Filter Rotor          Square Nut
 Install the oil filter rotor.
 Install the washer and tighten the square nut.
 Torque: 4.05.0kg-m


 Install the washer with the mark
    "OUTSIDE" facing up.




                                                               Washer

                                                  Oil Filter Rotor Cover      Screws
 Install the oil filter rotor cover.
 Check the gasket for wear or damage and
 replace if necessary.
 Install and tighten the three oil filter rotor
 cover screws.
 Torque: 0.30.4kg-m




                                                                                Dowel Pins

 RIGHT CRANKCASE COVER                               Bolts
 INSTALLATION
 First install the dowel pins and then install
 the gasket.
 Install the right crankcase cover and tighten
 the cover bolts.
 Torque: 0.81.2kg-m
 Tighten the right crankcase cover bolts
   diagonally.

                                                                           Right Crankcase Cover

                                                                                             9-8