movie 125 euro 3 Workshop-manual : Page 155

          14. BATTERY/CHARGING SYSTEM/
    A.C. GENERATOR                                  MOVIE SYSTEM

                                                    Battery Cover Screw
 BATTERY REMOVAL
 Remove the battery cover screws on the
 floor board.
 Open the battery cover and remove the
 battery by removing the bolt and band.
 First disconnect the battery negative (-)
 cable and then the positive (+) cable.
   When disconnecting the battery positive
   (+) cable, do not touch the frame with
   tool; otherwise it will cause short circuit
   and sparks to fire the fuel.
 The installation sequence is the reverse of
 removal.
   First connect the positive (+) cable and then
   negative (-) cable to avoid short circuit.
 BATTERY VOLTAGE (OPEN CIRCUIT
 VOLTAGE) INSPECTION
 Remove the floor board.
 Open the battery cover and disconnect the
 battery cables.
 Measure the voltage between the battery
 terminals.
 Fully charged : 13.1V
 Undercharged : 12.3V max.
 Battery charging inspection must be
   performed with a voltmeter.
 CHARGING
 Connect the charger positive (+) cable to the
 battery positive (+) terminal.
 Connect the charger negative (-) cable to the
 battery negative (-) terminal.
 · Keep flames and sparks away from a
   charging battery.
· Turn power ON/OFF at the charger, not
  at the battery terminals to prevent
  sparks near the battery to avoid
  explosion.
· Charge the battery according to the
               ifi d    h b
 · Quick charging should only be done in
   an emergency.
 · Measure the voltage 30 minutes after
   the battery is charged.

 Charging current : Standard : 0.9A
                    Quick : 3.0A
 Charging time : Standard : 510 hours
                    Quick : 30 minutes
 After charging: Open circuit voltage: 12.8V min.
                                                                 14-4