movie 125 euro 3 Workshop-manual : Page 60

          5. FUEL SYSTEM                                                               MOVIE SYSTEM


 Connect a hose to the fuel enriching circuit
 of the carburetor. Connect the auto
 bystarter yellow wire to the positive (+)
 terminal of a battery and green wire to the
 negative (-) terminal. Wait 5 minutes and
 blow the hose with mouth or vacuum pump.
 If the passage is blocked, the auto bystarter
 is normal.
 Disconnect the auto bystarter from the
 battery. Wait 30 minutes and blow the hose
 with mouth or vacuum pump. If air can be
 blown into the hose, the auto bystarter is                     Adopter
 normal.
                                                                                  Auto Bystarter

 REMOVAL
 Remove the set plate screws and set plate.
 Remove the auto bystarter from the
 carburetor.




                                                    Set Plate                              Screws

 AUTO BYSTARTER INSPECTION                         Bystarter Valve
 Check the auto bystarter valve and needle
 for nicks, wear or damage.
 If any faulty part is found, replace the auto
 bystarter as a set.




                                                                           Bystarter Needle
                                                                          Auto Bystarter
 INSTALLATION
 Insert the auto bystarter into the carburetor
 body until it bottoms.
 Position the set plate into the groove in the
 auto bystarter and tighten the screws.
 · Be sure to install the auto bystarter and
      set plate properly.
    · Install the set plate with its bottom face
      facing down.

                                                   Set Plate                                Screws

                                                                                               5-4