Choose your country
We work in partnership with many official Kymco dealers around the world.
You can select the country of your choice from the list below, whatever your choice, we can deliver worldwide!
14. FRONT WHEEL/FRONT SUSPENSION/
STEERING SYSTEM MXU 300/250
Adjust the tie-rod length.
Adjustment steps:
(The following procedures are done on both
tie-rods, right and left.)
Loosen the lock nuts.
Adjust the tie-rod length by tuning both tie-
rod ends.
Tie rod length:
299.50.5 mm (11.980.02 in)
Lock Nut Indentation Surface Lock Nut
To Knuckle Arm
Set the rod-end (steering column side) in an
angle where the indentation surface of the
tie-rod is parallel to the rod-end shaft, and
then tighten the lock nut.
Torque: 3 kgf-m (30 Nm, 22 lbf-ft)
Set the other rod-end (knuckle arm side) in
an angle as shown (right-hand tie-rod and
left-hand tie-rod), and then tighten the lock
nut. To Steering Column
Rod-end (tie rod) angle: 180
Torque: 3 kgf-m (30 Nm, 22 lbf-ft)
After making adjustment on both tie rods
be sure to mark them R and L for
identification.
The threads on both rod-end must be of
the same length.
14-16