15. REAR WHEEL/AXLE/SUSPENSION DRIVING MECHANISM MXU 300/250 Remove the swingarm bearing race and bearing plate by using the special tool. Special tool: Bearing puller E037 The removed bearing and dust seal must be replaced with new ones. Bearing Plate/Bearing Race Install the new swingarm bearing race and its new plate to the swingarm by using the special tool. Special tool: Oil seal & bearing installer E014 When installing the bearing plate, make sure that the bulge of bearing plate faces inside. Apply grease to the swingarm bearing and lips of dust seals, then install them into the swingarm with the special tool. Bearing/Dust Seal Special tool: Oil seal & bearing installer E014 Bolts Dust Plate Bearings Remove the three bolts and dust plate. Check the dust seal for wear or damage. Remove the O-ring. Dust Seal O-ring 15-39