16. ELECTRICAL EQUIPMENT VITALITY 50 BATTERY BATTERY REMOVAL 1. Make sure the ignition switch is OFF. 2. Remove the screw (1). 3. Push the two retainer clips (2) and remove the battery cover (3) 4. Disconnect the negative (-) terminal lead (1) from the battery first, then disconnect the positive (+) terminal lead (2). 5. Remove the battery. · This model adopts the battery which needs no refilling of distilled water. · When cleaning the terminals, remove the screws attaching the battery cover on the footboard and then open the battery cover. · When battery terminals are corroded, take out the battery for cleaning. · After cleaning, apply a thin coat of grease or vaseline to battery terminals and then install the battery. · Never open the closed-type battery electrolyte cap. · If the scooter will not be used for a long time, the battery will discharge electricity by itself. Remove the battery and put it in a cool place after it is fully charged to prevent electricity leakage. · If the scooter will not be used for a long time, remove the negative (-) terminal. · Do not smoke or allow flames or sparks near the battery while removing and installing it. · Turn off the ignition switch before removal or installation. The negative (-) terminal shall be removed first and the positive (+) terminal shall be installed first. · Tighten the loose terminal nuts securely. 16-5