movie 125 euro 3 Workshop-manual : Page 43

          3. INSPECTION/ADJUSTMENT                                         MOVIE SYSTEM

                                                      Cylinder Head Cover
 VALVE CLEARANCE
 Inspect and adjust valve clearance while
    the engine is cold (below 35).
 Remove the center cover.
 Remove the cylinder head cover.




                                                                            Bolts


 Turn the flywheel counterclockwise so that
 the "T" mark on the flywheel aligns with
 the index mark on the crankcase to bring the
 round hole on the camshaft gear facing up
 to the top dead center on the compression
 stroke.




                                                                            Punch Marks

                                                Valve Wrench
 Inspect and adjust the valve clearance.
 Valve Clearance: IN: 0.12mm
                    EX: 0.12mm
 Loosen the lock nut and adjust by turning
 the adjusting nut
  Special
 Valve Wrench
 · Check the valve clearance again after
      the lock nut is tightened.


 CARBURETOR IDLE SPEED                                Throttle Stop Screw
 · The engine must be warm for accurate
      idle speed inspection and adjustment.
 Remove the inspection cover.
 Warm up the engine before this operation.
 Start the engine and connect a tachometer.
 Turn the throttle stop screw to obtain the
 specified idle speed.
 Idle Speed: 1700100rpm
 When the engine misses or run erratic,
 adjust the pilot screw.

3-5