13. STEERINGHANDLEBAR/FRONTWHEEL/FRONT BRAKE/FRONTSHOCKABSORBER/FRONTFORK SUPER 9 50 Pack all bearing cavities with grease. Driver Handle Drive in the left bearing. Install the distance collar. Drive in the right bearing. · Do not allow the bearings to tilt while driving them in. · Drive in the bearing squarely with the sealed end facing out. Special Tools Outer driver Driver handle Outer Driver INSTALLATION Speedometer Gear Unit Apply grease to the speedometer gear unit. Install the speedometer gear unit by aligning its retaining pawl with the hub cutout. · If not aligned, the retaining pawl will be deformed when the axle nut is tightened. · After installing the axle, turn the wheel to make sure that the speedometer drive shaft rotates freely. Hub Cutout Pawl Install the front wheel by aligning the Tab speedometer gear unit groove with the front shock absorber tab. Insert the axle and tighten the axle nut. When installing the front wheel, position the brake disk between the two brake pads. Torque: 44.149.0N-m Groove Speedometer Gear Unit 13-7