14. REAR BRAKE/REAR FORK/REAR WHEEL/REAR SHOCK ABSORBER SUPER 9 50 REAR BRAKE (SH10DA) Brake Caliper Fluid Tube Bolt REAR BRAKE CALIPER REMOVAL First remove the exhaust muffler. ( 2-6) Remove the rear brake fluid tube bolt and disconnect the brake fluid tube. Remove the two bolts attaching the rear brake caliper. Remove the rear brake caliper. When removing the brake fluid tube, use shop towels to cover plastic parts and coated surfaces to avoid damage. Bolts Brake Pads INSPECTION Inspect the brake pads and brake disk. Visually check the brake pad thickness and it should not exceed the wear indicator mark. Measure the brake disk thickness. Service Limit: 3.0mm replace if below DISASSEMBLY Disassemble the rear brake caliper. ( 14-11) Inspect and assemble the rear brake caliper . ( 14-12) Note: The rear brake caliper and front brake caliper have the same specification. Wear Indicator Mark Brake Disk INSTALLATION Copper Washers Install the brake caliper to the rear fork and tighten the two bolts. Torque: 24.534.3N-m Connect the brake fluid tube to the brake caliper and tighten the fluid tube bolt. Fill the brake reservoir with the specified brake fluid and bleed air from the brake system. ( 13-11) When installing the brake fluid tube, be sure to install the two copper sealing washers. Fluid Tube Bolt Bolts 14-2