Choose your country
We work in partnership with many official Kymco dealers around the world.
You can select the country of your choice from the list below, whatever your choice, we can deliver worldwide!
6. CYLINDER HEAD/VALVES K-PIPE 50
Bolt Left Side Cover
CYLINDER HEAD REMOVAL
Remove the left crankcase cover bolt.
Remove the left crankcase cover.
Remove the crankshaft hole cap and timing
hole cap.
Remove the left side cover and gasket.
Remove the cam chain tensioner sealing bolt,
washer, spring and tensioner shaft.(See the
diagramp6-4-4)
Remove the valve inspection hole caps.
Align Bolt
Turn the crankshaft counterclockwise until
the "o" mark on the cam sprocket aligns with
the index mark on the cylinder head.
Make sure there slight clearances between the
valve stems and rocker arms by moving the
rocker arms up and down.
If the rocker arms are tight, turn the
crankshaft counterclockwise one full turn and
realign the "o" mark with the index mark.
Remove the cam sprocket bolts and cam
sprocket. Cam Sprocket
Suspend the cam chain with a wire or Cylinder Head Cover Cylinder Bolt
cord to prevent it from falling into the
cylinder.
Loosen the cylinder bolts.
Remove the bolt attaching the cylinder head
to the cylinder,
Remove the four nuts holding the cylinder
head cover,
Remove the cylinder head cover.
Nuts And Washers Cylinder Head Bolt
Gasket Inspection Hole Caps
Remove the cylinder head cover gasket.
Remove the cylinder head.
Remove the cylinder head gasket and dowel
pins.
Tensioner Sealing Bolt
6-4