super 9 3 Workshop-manual : Page 158

          13. STEERINGHANDLEBAR/FRONTWHEEL/FRONT
   BRAKE/FRONTSHOCKABSORBER/FRONTFORK SUPER 9                                          50


 Place the brake master cylinder on the
 handlebar and install the holder with the "up"
 mark facing up. Also align the punch mark
 with the holder joint seam.
 First tighten the upper bolt and then tighten
 the lower bolt.
 Torque: 9.813.72N-m




                                                   Fluid Tube Bolt       "Up" Mark


 Install the brake fluid tube with the attaching
 bolt and two sealing washers.
 Connect the front stop switch wire connector.
 Install the handlebar covers. ( 2-7)




                                                   Stop Switch Wire Connector



 BRAKE FLUID REFILLING
 Keep the handlebar upright and remove the
 brake reservoir cover and diaphragm.
 Add DOT-3 brake fluid to the brake
 reservoir.
 · When bleeding, be careful not to allow
     air in the brake reservoir flowing into
     the brake system.
   · When using a brake bleeder, follow the
     manufacturer`s instructions.
   · Never use dirty or unspecified brake
     fluid or mix different brake fluids be-
     cause it will damage the brake system.




                                                                                     13-10