super 9 3 Workshop-manual : Page 183

          15. ELECTRICAL EQUIPMENT                                             SUPER 9        50


 BATTERY                                            Front Tool Box

 BATTERY REMOVAL
 Open the front tool box and remove the bolt.
 Remove the front tool box. ( 2-4)
 Disconnect the battery cables.

   First disconnect the battery negative (-)
   cable and then the positive (+) cable.
 Remove the bolt and battery bracket.
 Remove the battery.
 The installation sequence is the reverse of
 removal.
 BATTERY CHARGING (OPEN CIRCUIT
 VOLTAGE) INSPECTION
 Remove the battery cover and disconnect the
 battery cables.
 Measure the voltage between the battery            Battery
 terminals.
 Fully charged : 13.0V13.2V
 Undercharged : 12.3V max.

   Battery charging inspection must be
   performed with an electric tester.

 CHARGING METHOD
 Connect the charger positive (+) cable to the
 battery positive (+) cable.
 Connect the charger negative (-) cable to the
 battery negative (-) cable.
 · Keep flames and sparks away from a
     charging battery.
   · Turn power ON/OFF at the charger,
     not at the battery terminals to prevent         Black           Power Lamp (Green)
     sparks near the battery.
   · Charge the battery according to the
     current specified on the battery surface.

 Charging current: Standard : 0.4A
                    Quick : 4A
 Charging time : Standard : 5 hours
                    Quick : 0.5 hours
 After charging: Open circuit voltage: 12.8V min.
 · Quick charging should only be done in
     an emergency.
   · During quick charging, the battery
     temperature should not exceed 45.
   · Measure the voltage 30 minutes after                     Red    Charging Lamp (Red)
     the battery is charged.

                                                                                  15-4