stryker 125 Workshop-manual : Page 116

          9. CLUTCH/GEAR SHIFT MECHANISM                                              STRYKER 125/150

                                                                               Square Nut
  Install the oil filter rotor.
  Install the washer and tighten the square nut.
  Torque: 4.05.0kg-m
 Install the washer with the mark
    "OUTSIDE" facing up.
  Install the special flange gasket onto the
  balance shaft driven gear with the flange
  facing down and then loosely install the
  square nut (left hand threads).
  Tighten the square nut using the square
  socket.                                                       Oil Filter Rotor
                                                   Oil Filter Rotor Cover     Screws
  Install the oil filter rotor cover.
  Check the gasket for wear or damage and
  replace if necessary.
  Install and tighten the three oil filter rotor
  cover screws.
  Torque: 0.30.4kg-m
  Install the oil pump gear cover and tighten
  the two bolts.




                                                                             Bolts
  RIGHT CRANKCASE COVER
  INSTALLATION
  First install the dowel pins and then install
  the gasket.
  Install the right crankcase cover and tighten
  the cover bolts.
  Torque: 0.81.2kg-m
 Tighten the right crankcase cover bolts
    diagonally.
                                                   Right Crankcase Cover           Bolts




9-9