stryker 125 Workshop-manual : Page 129

          10.CRANKCASE/CRANKSHAFT/TRANS-
   MISSION SYSTEM/STARTER SPINDLE                                           STRYKER 125/150
Middle Transmission Fork    Right Transmission Fork   · Cylinder head (Refer to Section 6.)



 Install the left transmission fork to the                 Transmission Fork Shaft
 countershaft 5th gear and install the fork
 guide pin into the transmission drum groove.
 Install the transmission fork shaft.

 After installation, make sure that the
    main shaft and countershaft are parallel.




 Install the crankshaft.                                             Dowel Pins

 Install the crankshaft squarely and do
    not strike it in forcedly.
 Install the dowel pins and gasket.




                                                               Gasket                Crankshaft

 CRANKCASE INSTALLATION
 · Install the left crankcase by aligning
      the starter spindle with the left
      crankcase hole.
    · When installing the left crankcase,
      make sure that the dowel pins and
      gasket do not tilt to avoid oil leakage.

 Tighten the eleven crankcase attaching
 screws.
 Torque: 0.81.2kg-m
 Tighten the crankcase attaching screws
    diagonally and evenly.

 Install the following parts:
 · Starter motor/generator/left crankcase
   cover/starter clutch/camshaft (Refer to
   Section 8.)
 · Clutch/gear shift mechanism (Refer to
   Section 9.)
 · Cylinder/piston (Refer to Section 7.)

                                                                                           10-12