quannon 125 Workshop-manual : Page 37

          3. LUBRICATION SYSTEM                                                     QUANNON125

                                                       Bolts
  OIL PUMP/OIL FILTER ROTOR
  REMOVAL
  1. Disconnect the clutch cable.
  2. Remove the right crankcase cover 13 bolts
     and right crankcase cover.
  3. Check the cover gasket, oil seal and O-ring
     for oil leaks or damage. Replace with new
     ones if necessary.
 When installing, make sure to use a new
   right crankcase cover gasket.
                                                       Right Crankcase Cover
                                                              Screws
  Remove the three screws attaching the oil
  filter rotor cover to remove the cover.
  Remove the oil filter rotor lock nut with a
  square socket and then remove the washer
  and oil filter rotor.
  Remove the oil pump cap two bolts.
 During installation, install the washer
    with the mark "OUTSIDE" facing up.


                                                       Oil Pump       Oil Filter Rotor


  Remove the 6mm nut on top of the oil pump
  driven gear.




                                                        Oil Pump Driven Gear
                                                   Oil Pump Body        Drive Gear

  Remove the oil pump driven gear and chain.
  Remove the oil pump mounting two bolts.
  Remove the oil pump body.




                                                                  Bolts


                                                                                         3-4